Câu 199: 200-301: Cisco Certified Network Associate (CCNA)

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their commonEthernet link. The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?

1. A. The OSPF area is not configured properly.
2. B. The priority on R1 should be set higher.
3. C. The cost on R1 should be set higher.
4. D. The hello and dead timers are not configured properly. — đáp án hiện tại
5. E. A backup designated router needs to be added to the network.
6. F. The OSPF process ID numbers must match.