Câu 48: 300-510: Implementing Cisco Service Provider Advanced Routing Solutions (SPRI)
Refer to the exhibit. After configuring IS-IS on routers R1 and R2, an engineer notices that only the loopback interface at 2000:1::1 /96 is known to router R2. Which change must be made so that only Loopback2 is advertised from R1 to R2?
Nội dung câu hỏi
Refer to the exhibit. After configuring IS-IS on routers R1 and R2, an engineer notices that only the loopback interface at 2000:1::1 /96 is known to router R2. Which change must be made so that only Loopback2 is advertised from R1 to R2?
Các lựa chọn
Đáp án được giữ gọn theo nhãn A, B, C, D trong phần bình chọn tương tác.
- A. Configure the router isis area1 command under the Loopback0 interface on R1.
- B. Remove the advertise passive-only command under the IS-IS address family ipv6 configuration — đáp án hiện tại
- C. Remove the ipv6 router isis area1 command under the Loopback2 interface on R1.
- D. Remove the passive-interface Loopback0 command under the router isis area1 configuration.
Cộng đồng
0 bình luận công khai. Tên thành viên được ẩn một phần.
Chưa có bình luận. Mở giao diện tương tác để bắt đầu thảo luận.