Câu 259: 350-401: Implementing Cisco Enterprise Network Core Technologies (ENCOR)

Refer to the exhibit. Rapid PVST+ is enabled on all switches. Which command set must be configured on Switch1 to achieve the following results on port fa0/1? ✑ When a device is connected, the port transitions immediately to a forwarding state. ✑ The interface should not send or receive BPDUs. ✑ If a BPDU is received, it continues operating normally.

1. A. Switch1(config)# spanning-tree portfast bpdufilter default Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast — đáp án hiện tại
2. B. Switch1(config)# spanning-tree portfast bpduguard default Switch 1 (config)# interface f0/1 Switch1 (config-if)# spanning-tree portfast
3. C. Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast
4. D. Switch1(config)# interface f0/1 Switch1(config-if)# spanning-tree portfast Switch1 (config-if)# spanning-tree bpduguard enable